ASTM C Standard Specification for Non-Structural Steel Framing Members is Per ASTM C, for conventional steel studs, the minimum base steel. 27 products Find ASTM C products and abstract using the BuildSite database. Get the right product for the spec. ASTM C Standard Specification for Nonstructural Steel Framing Members . standard by ASTM International, 06/01/ View all product details.
|Published (Last):||18 August 2009|
|PDF File Size:||3.46 Mb|
|ePub File Size:||17.14 Mb|
|Price:||Free* [*Free Regsitration Required]|
Prepare surfaces using the methods recommended by the manufacturer for achieving the best result for the substrate under the project conditions. Check with manufacturer for availability.
ASTM C – 07 Standard Specification for Nonstructural Steel Framing Members
Product Data for Credit MR 4. Based on deflection limits with adjustment to conform to a minimum safety factor of 1.
Already Subscribed to this document. Erect framing and panels plumb, level and square in strict accordance with approved drawings. For products where product manufacturing is within a mile radius of c6645 jobsite and the point of extraction of the raw materials. Comply with applicable provisions AWS D1. Butt all track joints.
Cut all framing components square for attachment to perpendicular members or as required for an angular fit against abutting members.
Standard Specification for Nonstructural Steel Framing Members
Studs and rigid furring channels shall have a configuration and steel thickness such that the system awtm which they are used will carry the design transverse loads without exceeding either the allowable stress of the steel or the allowable design deflection. Recycled Content of Steel Products: Securely anchor abutting pieces of track to a common structural element, or splice them together.
The values given in astn are mathematical conversions to SI units that are provided for information only and are not considered standard. Link to Active This link will always route to the current Active version of the standard. Product Data for Credit MR 5: Please first verify your email before subscribing to alerts. This standard is also available to be included in Standards Subscriptions. Install concrete anchors only after full compressive strength satm been achieved. Design framing systems to withstand design loads without deflections greater than the following:.
Contractor shall provide effective, full time quality control over all fabrication and erection complying with the pertinent codes and regulations of government agencies having jurisdiction.
Asmt fire-resistance-rated assemblies that wstm non-structural steel framing, provide asm and construction identical to those tested in assembly indicated according to ASTM E by, and displaying a classification label from, an independent testing agency acceptable to authority having jurisdiction. Subscription pricing is determined by: Rated assemblies to be substantiated from applicable testing using the proposed products, by Contractor. Where indicated in the drawings, provide for structural vertical movement using means in accordance with manufacturer’s recommendations.
Members shall be manufactured in such a fashion as to minimize burrs and sharp edges. Penetration test shall be done for performance requirements, wstm members shall be capable of pulling the head of the screw below the surface of the gypsum board without spin out. This standard does not purport to address all of the safety concerns, if any, associated with its use. Steel sheet members astj to reduce sound transmissions. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standards Subscriptions from ANSI provides a money-saving, multi-user solution for accessing standards. Do not install products under environmental conditions outside manufacturer’s recommended limits. Handle and lift prefabricated panels in a manner to not cause distortion in any member. Delete description not required. Attach wall stud bridging when required in a manner to prevent stud rotation. Track thickness to match wall stud thickness or as designed.
If more than one, identify the application or location where used or verify the designation and size is indicated on the drawings.
You may delete a document from your Alert Profile at any time. Steel Structural Products manufactures structural and drywall c-studs and track for use in both load and non-load bearing applications in the commercial and residential markets.