Stepping motor: mitsumi M42SP-5A. Motor Size: cm high by cm wide (shaft, gear and top plate, not calculated) This stepping motor have been removed. M42SP-6TA LOT NO.T 10(OHMS) Mitsumi stepper Motor 1: M42SP-5A Label ON MOTOR: STEPPING MOTOR MITSUMI M42SP-5A STEP LOT NO. The mitsumi M42sp-4np is a stepper motot available on various devices http://

Author: Meshicage Sagrel
Country: Costa Rica
Language: English (Spanish)
Genre: Technology
Published (Last): 3 March 2016
Pages: 487
PDF File Size: 10.8 Mb
ePub File Size: 8.66 Mb
ISBN: 984-3-56121-864-3
Downloads: 21647
Price: Free* [*Free Regsitration Required]
Uploader: Tojalkis

Typically these motors do not settle down and display a constant ohm value.

Replacing a 4 pin leaded inductor with a 2 pin Started by gkmaia Yesterday at The first two have very low resistance, and the second pair has very low resistance.

After a small search, I found this. I was sorta expecting at least 5 wires, one of the wires being ground and the other 4 being the different windings. Where would the center taps be? The mitsumi M42sp-4np is a stepper motot available on various devices like scanners, fax, etc.

Just saying hello Started by MichaelaJoy Yesterday at 6: This is the best tutorial I’ve seen. I saw that it said unipolar also, but I m42zp think that it should act differently on a tester if it was a unipolar.


M42SP-5,-5K | Stepping Motors | MITSUMI

And also tell me maximum pulse per second. Also, I have read that bipolar motors usually have only four wires. By continuing to m42ps this site, you are consenting to our use of cookies.

As I stated before, I’m sorta ignorant about steppre motors, but I did find out a little more by just checking around with a tester.

I salvaged two Mitsumi m42sp-5a, http: Submit Your Business today Stepping Motors – Parallax Inc. Stepper motors have 4 or more wires going into them. Rotor can be moved by sequentially applying a pulsed DC voltage to one or n42sp coils at a time. To participate you need to register.

Stepping motor: mitsumi M42SP-5A

n42sp I am taking this to mean that it is a bipolar motor as Nigel suggested earlier. Hi User Abuser, I found something wrong in your article.

Since you’re kinda new to the whole stepper motor thing, here’s a link I supplied for an earlier post in one of the other forums. Skip to main content. How much harder are they to control than a unipolar? Click here to register now. I take this to mean the motor is a unipolar wound device.


If possible, tell me the voltage and current ratings. Potentiometer Questions Started by norbss Yesterday at N42sp this a bipolar motor? All you need is a web browser ie. Could I still run it directly from a PIC with an isolator circuit?

Inventory Stock M42SP-5A , EM-91 , MSCS048N58

There are only four wires. Electro Tech is an online community with overmembers who enjoy talking about and building electronic circuits, projects and gadgets. M4s2p New media New comments Search media. Thank you for this! The M42SP-4NP is a standard, four-phase unipolar stepper motor that is easily controlled when buffered with an appropriate high-current driver ULN or similar suggested.

The case may be acting as the center tap on this one. I would like to first state that this is the first time I have attempted to use a stepper motor. Publicado por User Abuser en Despite the modest body size 5w.